Conditionnement : 100mg
Synonyms: Acetylcolina
| Description | Acetylcholine iodide (Acetylcolina) is a neurotransmitter found at neuromuscular junctions, autonomic ganglia, parasympathetic effector junctions, a subset of sympathetic effector junctions, and at many sites in the central nervous system. |
| In vitro | Acetylcholine iodide (Ach) stimulated SBC3 cell proliferation, adhesion and migration toward fibronectin (Fn) in a dose-dependent manner[1]. ACh ameliorates TNF-α-induced calpain activation by decreasing p38-MAPK phosphorylation and enhancing calpastatin expression. It elicits an anti-apoptotic effect through the activation of the muscarinic ACh receptor (MAChR) and the activation of anti-oxidant systems. ACh increases cell viability and decreases TNF-α-induced apoptosis in H9c2 cells[2]. |
| In vivo | Acetylcholine can inhibit pro-inflammatory cytokine release and protect against cardiomyocyte injury[2]. |
| Synonyms | Acetylcolina |
| Cell Research | The SBC3 cells are seeded at 2000 cells/well in treated 96-well plates maintained with RPMI1640 medium containing 10% (v/v) FCS for 24 h. The medium is removed and replaced with 100 μl RPMI1640 containing 1% (v/v) ITS. The cells are incubated in serum free medium for 24 h to synchronize the cell cycle. Then another 100 μl serum-free medium containing the agonist/antagonist under investigation is added. The antagonist is added 30 min before Ach(Acetylcholine iodide). At this time, the cells in a duplicate plate are given 100 μl serum-free medium and a MTT assay is used to determine live cell numbers before treatment with the agonist/antagonist as measured by the absorbance (OD) at 550 nm/650 nm. After 24, 48 or 72 h culture, the remaining cells are assayed to yield post-agonist/antagonist cell numbers using the same method. All the experiments are performed in triplicate.(Only for Reference) |
| Molecular Weight | 273.11 |
| Formula | C7H16NO2·I |
| Cas No. | 2260-50-6 |
| Smiles | CC(=O)OCC[N+](C)(C)C.[I-] |
| Relative Density. | 1.4816 g/cm3 (Estimated) |
| Storage | Powder: -20°C for 3 years | In solvent: -80°C for 1 year Shipping with blue ice/Shipping at ambient temperature. | |||||||||||||||||||||||||||||||||||
| Solubility Information | DMSO: 50 mg/mL (183.08 mM), Sonication is recommended.  H2O: 250 mg/mL (915.38 mM), Sonication is recommended. | |||||||||||||||||||||||||||||||||||
| In Vivo Formulation | 10% DMSO+40% PEG300+5% Tween 80+45% Saline: 2 mg/mL (7.32 mM), Sonication is recommended. Please add the solvents sequentially, clarifying the solution as much as possible before adding the next one. Dissolve by heating and/or sonication if necessary. Working solution is recommended to be prepared and used immediately. The formulation provided above is for reference purposes only. In vivo formulations may vary and should be modified based on specific experimental conditions. | |||||||||||||||||||||||||||||||||||
Solution Preparation Table | ||||||||||||||||||||||||||||||||||||
DMSO/H2O
Note : The dilution table applies only to solid products. For liquid products, please calculate the stock solution based on the stated concentration and/or density. | ||||||||||||||||||||||||||||||||||||
For example, if the intended dosage is 10 mg/kg for animals weighing 20 g , with a dosing volume of 100 μL per animal, and a total of 10 animals are to be administered, using a formulation of 
10% DMSO+ 40% PEG300+ 5% Tween 80+ 45% Saline/PBS/ddH2O , the resulting working solution concentration would be 2 mg/mL.Dissolve 2 mg of the compound in 100 μL DMSO to obtain a stock solution at a concentration of 20 mg/mL . If the required concentration exceeds the compound's known solubility, please contact us for technical support before proceeding.
1) Add 100 μL of the DMSO stock solution to 400 µL PEG300 and mix thoroughly until the solution becomes clear.
2) Add 50 µL Tween 80 and mix well until fully clarified.
3) Add 450 µL Saline,PBS or ddH2O and mix thoroughly until a homogeneous solution is obtained.
| Size | Quantity | Unit Price | Amount | Operation |
|---|
