Size : 1g
Synonyms: Vitamin H, Vitamin B7, D-Biotin
| Description | Biotin (Vitamin H) is a water-soluble B-vitamin and is necessary for cell growth, the production of fatty acids, and the metabolism of fats and amino acids. |
| In vitro | METHODS: To induce significant biotinylation of neighboring proteins, supplementation with Biotin is required at concentrations typically between 10-50 µM, with optimal incubation times between 15-18 h, after which total biotinylation plateaus. RESULTS: Due to the formation of covalent bonds between biotin and lysine residues on proteins, biotinylation appears to remain constant throughout the life cycle of the protein and can withstand stringent cleavage and washing conditions, thus maximizing the purity of isolated proteins identified by MS. The identified proteins can then be investigated as candidate interactors with POIs. [1] METHODS: Mouse oligodendrocytes 158N were treated with Biotin (1-1000 nM) for 2 h, followed by the addition of 7β-OHC (50 µM) for a further 24 h. Cell viability was measured by MTT Assay. RESULTS: 7β-OHC-induced cytotoxicity was only prevented by Biotin at a concentration of 10-1000 nM. [2] |
| In vivo | Biotin serves as a coenzyme for carboxylases, involved in the synthesis of fatty acids, isoleucine, and valine, as well as in gluconeogenesis. In biological research, it is primarily used to label proteins for biochemical studies. |
| Synonyms | Vitamin H, Vitamin B7, D-Biotin |
| Molecular Weight | 244.31 |
| Formula | C10H16N2O3S |
| Cas No. | 58-85-5 |
| Smiles | C(CCCC(O)=O)[C@H]1[C@@]2([C@@](NC(=O)N2)(CS1)23)23 |
| Relative Density. | 1.267 g/cm3 |
| Storage | Keep away from direct sunlight,Store at low temperature Powder: -20°C for 3 years | In solvent: -80°C for 1 year Shipping with blue ice/Shipping at ambient temperature. | |||||||||||||||||||||||||||||||||||
| Solubility Information | Ethanol: < 1 mg/mL (insoluble or slightly soluble) DMSO: 130 mg/mL (532.11 mM), Sonication is recommended.  | |||||||||||||||||||||||||||||||||||
| In Vivo Formulation | 10% DMSO+40% PEG300+5% Tween 80+45% Saline: 4.6 mg/mL (18.83 mM), Solution. Please add the solvents sequentially, clarifying the solution as much as possible before adding the next one. Dissolve by heating and/or sonication if necessary. Working solution is recommended to be prepared and used immediately. The formulation provided above is for reference purposes only. In vivo formulations may vary and should be modified based on specific experimental conditions. | |||||||||||||||||||||||||||||||||||
Solution Preparation Table | ||||||||||||||||||||||||||||||||||||
DMSO
Note : The dilution table applies only to solid products. For liquid products, please calculate the stock solution based on the stated concentration and/or density. | ||||||||||||||||||||||||||||||||||||
For example, if the intended dosage is 10 mg/kg for animals weighing 20 g , with a dosing volume of 100 μL per animal, and a total of 10 animals are to be administered, using a formulation of 
10% DMSO+ 40% PEG300+ 5% Tween 80+ 45% Saline/PBS/ddH2O , the resulting working solution concentration would be 2 mg/mL.Dissolve 2 mg of the compound in 100 μL DMSO to obtain a stock solution at a concentration of 20 mg/mL . If the required concentration exceeds the compound's known solubility, please contact us for technical support before proceeding.
1) Add 100 μL of the DMSO stock solution to 400 µL PEG300 and mix thoroughly until the solution becomes clear.
2) Add 50 µL Tween 80 and mix well until fully clarified.
3) Add 450 µL Saline,PBS or ddH2O and mix thoroughly until a homogeneous solution is obtained.
| Size | Quantity | Unit Price | Amount | Operation |
|---|
